ENGLISH
13) Remove the platforms and drain pan and place a bucket under the beer tap.
14) Press the liquid button to dispense water from the liquid nozzle. Repeat a few times until no more water comes out.
Then, press the foam button to dispense water from the foam nozzle. Repeat a few times until no more water comes out.
15) When no more water comes out of the nozzle, keep the beer tap lever in the open position and turn the regulator adjust dial
to set the pressure to "0" (MPa).
16) Close the main valve of the CO2 gas cylinder by turning it clockwise.
17) When CO2 gas stops coming out of the nozzle, press the stop button to close the beer tap.
18) Close the beer circuit.
Rotary type: Turn the keg coupler handle counterclockwise until it stops.
Vertical type: Unlock and lift the keg coupler handle all the way up.
19) Turn the keg coupler counterclockwise
to remove it from the cleaning tank.
20) Turn the keg coupler clockwise to attach it to the beer keg.
Note: Wash the joint between the keg coupler and beer keg if it is not clean.
21) Wash the cleaning tank interior thoroughly, turn the tank upside down to dry, and cap it tightly for storage.
22) Set the platform on the arms.
23) Press the flush button on the operation panel. Check that the flush lamp goes off and the sold out lamp comes on.
24) Wipe off moisture from the end of the beer tap nozzles. Clean and attach the nozzle caps (accessory).
Note: Always attach the accessory nozzle caps at the end of dispensing operation or during periods of non-use to
prevent entrance of insects or dirt into the beer tap nozzles.
3. DRAIN PAN AND GRILLE (DAILY)
1) Lift up the front of the drain pan and pull it off toward you.
Note: Be careful not to spill water and beer in the drain pan.
2) Wash the grille and drain pan with tap water.
3) Set the grille on the drain pan and fit the drain pan by pushing
it securely into the drain pan support.
4. PLATFORM (DAILY)
1) Slightly lift up and remove the platform from the arms.
2) Lift the cover off the platform.
3) Wash the cover and platform with tap water. Use warm water and a cloth or sponge to remove dirt
buildup in the gaps.
4) Insert the cover into the platform until it hooks up.
5) Refit the platform to the arms.
Rotary Type
Vertical Type
Grille
(1) Lift up front
22
Keg Coupler Handle
Rotary Type
Rotary Type
(2) Pull off
Drain Pan
Cover
Guide
Vertical Type
Vertical Type
Nozzle Cap
Hook