Environmental Conditions; Construction Specifications; Compliance With International Standards - Chauvin Arnoux C.A 6549 Manual De Instrucciones

q
Minimum battery life (as per Nf EN 61557-2)
Test voltage
Nominal load
Nbr. of 5s measurements on
nominal load
(with 25s pauses between
measurements)
q
Mean battery life
Assuming a 1-minute DAR measurement 10 times a day and a 10-minute PI measurement 5 times a
day, the battery life will be approximately 15 working days, or 3 weeks.
q
Charging time
6 hours to recover 100% capacity (10 hours if the battery is completely run down)
0.5 hours to recover 10% capacity (battery life approximately 2 days)
Remark: it is possible to charge the batteries while making insulation measurements, provided that the
values measured are greater than 20 MΩ. In that case, the charging time is longer than 6 hours, and
depends on the frequency of the measurements made.
7.4

ENVIRONMENTAL CONDITIONS

q
Operation
§
While batteries are charging
-10°C to 40°C and 10% to 80 % relative humidity
§
During measurement
-10°C to 35°C and 10% to 75% relative humidity
-10°C to 55°C and 10% to 80% relative humidity
q
Storage
-40°C to 70°C
10% to 90% relative humidity
q
Altitude : < 2000m
7.5

CONSTRUCTION SPECIFICATIONS

q
Overall dimensions of the instrument (L x l x h) : 270 x 250 x 180mm
q
Weight : approx. 4,3kg
7.6

COMPLIANCE WITH INTERNATIONAL STANDARDS

q Electrical safety as per :
q Double insulation:
q Pollution level : 2
q Measurement category : III
q Max. voltage relative to earth : 1000 V (2500 V in measurement category I)
7.6.1. ELECTROMAGNETIC COMPATIBILITY :
NF EN 61326-1 (Ed. 97) + A1, industrial environment category
7.6.2. MECHANICAL PROTECTION
IP 53 as per NF EN 60529 (Ed. 92)
IK 04 as per NF EN 50102 (Ed. 95)
500 V 1000 V
500 kΩ 1 MΩ
6500 5500
EN 61010-1 (Ed. 2 of 2001), EN 61557 (Ed. 97)
90
2500 V 5000 V
2,5 MΩ 5 MΩ
4000 1500