Printing Measured Values (Print Key) - Chauvin Arnoux C.A 6549 Manual De Instrucciones

q Estimate of result recableing capacity
Total memory space:
Internal management:
Memory space available:
An insulation measurement result requires approximately 80 bytes.
It is therefore possible to recable approximately 1500 insulation measurements.
q Memory space available
This function is automatically activated when a result is recorded.
Press MEM once to obtain the next free OBJ. TEST number; the bargraph indication is proportional to the
free memory available.
- If the entire memory is free, the bargraph is completely empty.
- If the entire memory is full, the bargraph is all black.
One segment of the bargraph represents approximately 50 records.
MR SECONDARY FUNCTION
6.2.2
The MR function is used to recall any data from memory, whatever the active position of the rotary switch,
except for the OFF and SET-UP positions.
When the MR key is activated, the following screen is displayed.
After selecting the Obj. Test, press 4to access the first item of information relative to this measurement.
To access the other items, press DISPLAY repeatedly, or GRAPH , if the mode selected before the
measurement was begun allows.
To exit from the MR function, press MR again or turn the switch.
6.3 PRINTING MEASURED VALUES : PRINT KEY
Pressing the PRINT key gives access to the menu below :
128 Kbytes
8 Kbytes
120 Kbytes
The flashing cursor identifies the last occupied Obj.
Test number, here
47 : 99
Use the4,3,5 and 6keys to select the desired Obj.
Test number.
q
Print result :
immediate printing of the measurement : following a
measurement or after access to the MR mode.
q
Print memory
printing of stored data
q
Baud rate / Port
baud rate adjusted in the SET-UP menu (cf. § 4.5).
80