Publicidad
Idiomas disponibles
Idiomas disponibles
KEY
The following symbols have been used in the discussion:
Situation of general danger. Failure to respect the instructions that follow may cause harm to persons and property.
Situation of electric shock hazard. Failure to respect the instructions that follow may cause a situation of grave risk for personal safety.
Notes and important remarks.
IMPORTANT WARNINGS AND SAFETY RECOMMENDATIONS
This manual concerns the products DAB "E.SWIM" and "E.SWIM SVRS", and is valid for the firmware version 2.x.
GENERAL RISK FACTORS
Before installation, carefully read this manual which contains important information for use of the product. This document must be
kept so that it can also be consulted afterwards.
Installation and operation must comply with the local safety regulations in force in the country in which the product is installed.
Everything must be done in a workmanlike manner.
Failure to respect the safety regulations not only causes risk to personal safety and damage to the equipment, but invalidates every
right to assistance under guarantee.
INSTALLATION AND MAINTENANCE BY QUALIFIED PERSONNEL
This product should be installed and serviced only by authorized competent and skilled service personnel.
The term skilled personnel means persons whose training, experience and instruction, as well as their knowledge of the respective
standards and requirements for accident prevention and working conditions, have been approved by the person in charge of plant
safety, authorizing them to perform all the necessary activities, during which they are able to recognize and avoid all dangers.
(Definition for technical personnel IEC 60364.
We suggest special maintenance at least once a year by qualified personnel.
USE ONLY BY COMPETENT PERSONS
The appliance may be used by children over 8 years old and by persons with reduced physical, sensory or mental capacities, or who
lack experience or knowledge, on condition that they are under supervision or after they have received instructions concerning the
safe use of the appliance and the understanding of the dangers involved. Children must not play with the appliance. Cleaning and
maintenance intended to be carried out by the user must not be performed by children without supervision.
MECHANICAL SAFETY
NEVER LET THE PUMP RUN WITHOUT WATER.
Water also performs the functions of lubricating, cooling and protecting the seals: dry running can cause permanent damage
to the pump and will void the guarantee.
Always fill the filter before starting the pump.
‐
‐
Protect the pump from unfavourable weather conditions.
For a period of inactivity, keep the pump supplied with the "Anti-Lock" function active (paragraph 6.2.9), to avoid mechanical
‐
blocking of the pump.
‐
In case of exposure to frost:
for short periods, keep the pump supplied and activate the "Anti-Lock" function (paragraph 6.2.8);
for long periods, disconnect the pump from the power supply, remove all the caps and completely drain the pump body.
‐
Keep the caps!
‐
To use as an outdoor pump, provide suitable protection and install the pump on an insulating base at least 100 mm high.
‐
Store the pumps in a dry covered area, with constant air humidity.
‐
Do not wrap the motor in plastic bags! Risk of condensation!
If testing the seal of the pipes at a pressure higher than 2.5 bar, exclude the pump (close the gate valves before and after the
pump).
ENGLISH
2
Publicidad
