RS Pro RS-33S Manual De Instrucciones página 17

5. USING COMPARATOR FUNCTION (99 SETS)
5-1 Comparator
The comparator function compares the measured values with preset High and Low
limit values for internal resistance and voltage. If the measured values are within the
set limits the PASS symbol is displayed. If the measured values are outside limits the
WARNING or FAIL symbol is displayed and the beeper is sounded..
5-2 Comparator Settings
1. Rotate the range switch to any resistance range.
2. Press and hold down the "COMP" key for 2 seconds, the display will show
"COMP" in the comparator setting mode.
3. Use or
4. Press key once, the first digit on the high limit resistance will start flashing, use
the &
digits, the decimal point, and the resistance units.
5. Press key once, the first digit on the low limit resistance will start flashing, use
the and
three digits, the decimal point, and the resistance units.
6. Press key once, the first digit on the high limit voltage will start to flash, use the
and
digits and the decimal point.
7. Press key once, the first digit on the low limit voltage will start to flash, use the
and
digits and the decimal point.
8. Repeat step 3 to step 7 to set the next comparator number.
9. Press COMP key again to exit.
high limit resistance
high limit voltage
09/15/17 Version No. 00
key to change the comparator number, from 01 up to 99.
keys to select the desired value. Repeat this step to set the next three
keys to select the desired value. Repeat this step to set the next
keys to select the desired value. Repeat this step to set the next three
keys to select the desired value. Repeat this step to set the next three
comparator number
Battery Capacity Tester / EN
low limit resistance
low limit voltage
14