ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1.
Control panel
2.
Level 1
3.
Level 2
Level 3
4.
5.
Level 4
6.
Level 5
7.
Level guides
Rack
8.
9.
Tray
Fig. 2 Control panel
Oven functions
1.
2.
Functions knob
3.
Display
4.
Temperature/Time icon
Decrease icon
5.
6.
Increase icon
7.
Start/Pause icon
8.
Child Lock icon
Alarm icon
9.
10. Cooking time setting icon
11. Delay end setting icon
12. Time setting icon
NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
-
This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
-
Make sure all parts and components are included and in good conditions. If there is any
50
Bolero Hexa AF319000 Inox A
piece missing or in bad conditions, contact the Official Cecotec Technical Support Service
immediately.
The oven guides are numbered from bottom to top. 4th and 5th guides are mainly used for grill
function.
Accessories
1. Oven rack. For dishes, cake tins, roasting and grilling trays.
2. Baking tray. For cakes and cookies.
The rack and baking tray must be placed correctly on the side guides. Be careful when
removing the trays/containers from the oven, as they are very hot surfaces, and you could
burn yourself.
If you use the baking tray to collect the fat that falls from the food, be sure to place it
correctly on the side guides. Allowing these accessories to come into contact with the
bottom surface of the oven may damage the enamel. If you place trays or containers on
the first guide starting from the bottom, you must leave a distance of at least 2 cm from
the bottom surface of the oven.
3. Basket. Use this accessory with the Air Fry mode: this basket can be placed on the oven
rack or on the side guides in the same way as the tray.
Box content
-
Oven
-
Baking tray
-
Rack
-
Air fry basket
-
Pizza tray
-
Instruction manual
3. INSTALLATION
To ensure the correct operation of the appliance, make sure the piece of furniture is suitable
for built-in installation. Figure 3 shows the dimensions of the cut-out for installation under the
worktop or in a high cabinet.
-
To ensure adequate ventilation, the rear panel of the cabinet must be removed. It is
preferable to install the oven so that it rests on two wooden slats. If the oven rests on a
flat surface, there must be an opening of at least 45×560 mm, like shown in figure 4.
-
Adjacent cabinet panels shall be made of heat-resistant material. In particular, enclosures
with a veneered exterior must be assembled with glues that can withstand temperatures
up to 100˚C.
-
In compliance with current safety regulations, it must not be possible to come into contact
ENGLISH
51
Bolero Hexa AF319000 Inox A