Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY APPLIANCES IN BANKS
To assemble appliances in
banks (side by side) pro-
ceed as described below.
1 - Apply
food-approved
sealant to the edges to
be placed side by side.
2 - Place the appliances
side by side.
3 - Connect the appliance
using the screws and
nuts (A-B).
4 - Remove
the
excess
sealant.
5 - Apply the sealant to the inside of the lid (C), and
fit it to cover the fixing zone.
A variety of optional installation kits are available for
arranging appliances in banks:
D)"Bridge" installation kit
GAS CONNECTION
Important
Those authorised to carry out this opera-
tion must have experience acquired and
certified in the specific sector, must make
the connection to the proper standards,
and must comply with all the relevant regu-
lations and legislation. Once the connec-
tion has been made, before the appliance is
put into operation a general check must be
made to ensure there are no gas leaks.
To make the connection, connect the mains line to
the appliance's connection pipe, fitting a shut-off
tap (A), to allow the gas supply to be cut off when
necessary.
B
A
Important
The tap (A), not supplied with the appliance,
must be installed in an easily accessible
position and its status (on or off) must be
obvious at a glance.
- 15 -
C
IDM-39616001500.tif
D
IDM-39605901700.tif
A
IDM-39604005700.tif
IT
GB
DE
FR
ES
English
Publicidad
