REPLACEMENT OF THE PILOT LIGHT INJECTOR
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off knob (A) and dis-
assemble handle (B).
3 - Remove the knob units
(G).
4 - Undo the screws (C) and
remove the panel (D).
5 - Unscrew the union (E).
6 - Remove the nozzle (F)
and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
7 - Retighten the union (E).
DECOMMISSIONING AND SCRAPPING THE APPLIANCE
When decommissioning the appliance, a series of
procedures must be carried out to ensure that the
appliance and its components are not a hindrance
and are not easily accessible.
To ensure that the appliance cannot constitute haz-
IT
ards for people or the environment, all energy
sources (electricity, etc.) must be disconnected and
GB
rendered unusable, and any liquids present must
be drained (lubricants, fluids, etc.).
DE
Place the appliance in a suitable area which is not
easily accessible, with barriers to prevent anyone
from accessing it.
FR
ES
English
A
B
G
8 - Restore the initial conditions after completing
When scrapping, sort all components by chemical
characteristics and dispose of them separately in
accordance with the relevant legal requirements.
Do not dump non-biodegradable products,
lubricating oils, and non-metallic compo-
nents (rubber, PVC, resins, etc.) in the envi-
ronment. Dispose of them in compliance
with the relevant laws.
- 20 -
C D C
the operation.
Important
F
E
IDM-39605901100.tif