Publicidad
Idiomas disponibles
Idiomas disponibles
3. Safety / 4. Transport, packaging and storage
3.7 Compliance with 3-A conformity
For a 3-A-compliant connection, the following seals have to be used:
For milk thread fittings per DIN 11851, suitable profile seals have to be used (e.g. SKS
■
Komponenten BV or Kieselmann GmbH).
For fittings per IDF, seals with support ring per ISO 2853 have to be used.
■
Note: Connections per Svensk Standard SS 1145, APV RJT and NEUMO Connect S are
not 3-A-compliant.
EN
3.8 Compliance with EHEDG conformity
For an EHEDG-compliant connection, seals in accordance with the current EHEDG
policy document must be used.
Seals for connections per ISO 2852, DIN 32676 and BS 4825 part 3 are, e.g., manufac-
tured by Combifit International B.V.
A manufacturer of seals for connections per DIN 11851 is, e.g., Kieselmann GmbH.
A manufacturer of NEUMO BioConnect
To maintain the EHEDG certification, one of the process connections recommended by
EHEDG must be used. These are marked with the logo in the data sheet.
4. Transport, packaging and storage
4.1 Transport
Check the instrument for any damage that may have been caused.
Obvious damage must be reported immediately.
CAUTION!
Damage through improper transport
With improper transport, a high level of damage to property can occur.
▶
When unloading packed goods upon delivery as well as during internal
transport, proceed carefully and observe the symbols on the packaging.
▶
With internal transport, observe the instructions in chapter 4.2 "Packaging
and storage".
If the instrument is transported from a cold into a warm environment, the formation of
condensation may result in instrument malfunction. Before putting it back into operation,
wait for the instrument temperature and the room temperature to equalise.
16
®
seals is, e.g., NEUMO GmbH & Co. KG.
WIKA operating instructions, model DMSU22SA
Publicidad
