WIKA DMSU22SA Manual De Instrucciones página 29

8. Configuration via display and operating unit
8.2 Setting the units
8.2.1 Setting the pressure unit
1. Open the operating menu with [↵].
Select "Basic setting" and confirm with [↵].
2. Select "Application" and confirm with [↵].
3. Select "Pressure" and confirm with [↵].
4. Select "Unit" and confirm with [↵].
5. Select pressure unit and confirm with [↵].
» Pressure unit is set.
8.2.2 Setting the temperature unit
Temperature unit °C and °F selectable.
1. Open the operating menu with [↵].
Select "Basic setting" and confirm with [↵].
2. Select "Application" and confirm with [↵].
3. Select "Sensor temp." and confirm with [↵].
4. Select temperature unit and confirm with [↵].
»Temperature unit is set.
8.3 Scaling the measuring range
8.3.1 Performing a wet adjustment
For the start of the measuring range and end of the measuring range, the values will be
taken from the running measurement. The respective output signal can be adjusted.
Requirement Measurement is running.
Setting range Max. turndown: 4 : 1, however ≥ 4 bar
WIKA operating instructions, model DMSU22SA
EN
29