WIKA DMSU22SA Manual De Instrucciones página 24

6. Display and operating unit
6.4 Setting the main display
The main display can show the following values:
Pressure
■
Level
■
Volume
■
Current
EN ■
PV percent
■
Sensor temperature Temperature at the sensor is displayed.
■
PV (primary value) The value corresponding to the mode will be displayed.
■
1. Open the operating menu with [↵].
Select "Display" and confirm with [↵].
2. Select "Main display" and confirm with [↵].
3. Select value and confirm with [↵].
» Main display shows the selected value.
6.5 Setting the additional display
The additional display can show the following values:
Measured values
Pressure
■
Level
■
Volume
■
Current
■
PV percent
■
Sensor temperature Temperature at the sensor is displayed.
■
PV (primary value) The value corresponding to the mode will be displayed.
■
Drag pointer values
P /P
■
min max
PV /PV
■
min max
T /T
■
min max
24
Applied pressure is displayed.
Level mode is not supported on this instrument.
Volume mode is not supported on this instrument.
Output signal is displayed.
Output signal is displayed as a percentage.
If the mode is changed, then the main display will change.
Applied pressure is displayed.
Level mode is not supported on this instrument.
Volume mode is not supported on this instrument.
Output signal is displayed.
Output signal is displayed as a percentage.
If the mode is changed, then the main display will change.
WIKA operating instructions, model DMSU22SA