MN002407A01-AK
Chapter 2: Operational Safety Guidelines
Chapter 2
Operational Safety Guidelines
●
This equipment is not suitable for outdoor use. Use only in dry locations or conditions.
●
Maximum ambient temperature around the charger must not exceed 40°C (104°F).
●
While a radio is in a charger pocket, the radio may be on only if the radio is transmitting data wirelessly,
such as using Wi-Fi. Otherwise, turn off the radio.
●
Connect the charger to an AC outlet using only a Motorola Solutions-authorized power supply. Refer to
MSI Authorized Power Supplies and Power Cords
●
The equipment shall be connected to a nearby and easily accessible socket outlet.
●
Make sure that the power cord is located where it will not be stepped on, tripped over, or subjected to
water, damage, or stress.
●
Connect the power cord only to an appropriately fused and wired AC outlet with the correct voltage, as
specified on the product.
●
Disconnect from line voltage by removing the power cord from the AC outlet.
●
Connect no more than the appropriate number of chargers to a 15-A circuit or 20-A circuit, as limited by
any certified power strip being used.
NOTE: Motorola Solutions does not recommend daisy chaining power strips. Limit circuit loading
below 80% of the circuit rating.
●
Use only Motorola Solutions Authorized Pockets.
2.1
Supported Models
Table 1: Supported Models and Description
Kit (Part Number)
PS000029A02
PS000029A05 (Europe/United King-
dom)
PS000029A07 (South Korea)
PS000029A10 (Australia/New Zealand)
PS000029A03/PS000029A11 (United
States/Australia/New Zealand/Brazil)
PS000029A09/PS000029A12 (Europe/
United Kingdom)
PS000029A08 (South Korea)
PS000337A01 (United States/North
America/Australia/New Zealand)
12
.
Description
APX 6-Display IMPRES 2 Multi-Unit Charger with Charger
Reprogramming and Fleet Management
APX 6-Display IMPRES 2 Multi-Unit Charger with Charger
Reprogramming, Fleet Management, and USB Accessory
Charging
APX NEXT 6-Display IMPRES 2 Multi-Unit Charger with
Charger Reprogramming and Fleet Management