Motorola Solutions IMPRES 2 Guia Del Usuario página 27

Status
Fault
Standby
● Battery is waiting to rapid
charge.
● Battery is too hot, too
cold, or low voltage.
● Charger is too hot.
Table 9: Charging Indications for IMPRES 2 or IMPRES Battery Calibration (Calibration Initially
Disabled, Then Enabled)
Status
Charger Powers On
Battery Detected
Requesting IMPRES Battery
Calibration
● Calibration is disabled in
charger.
● Battery is charging.
Pocket Display
WARNING:
NOT CHARGEABLE
REMOVE & REINSERT
WARNING:
HOT BATTERY
WAITING TO CAL
OR
COLD BATTERY
WAITING TO CAL
OR
VERY LOW BATTERY
WAITING TO CHRGE
OR
HOT CHARGER
WAITING TO CAL
Pocket Display
IMPRES 2
CHARGER
IMPRES 2
BATTERY
OR
IMPRES
BATTERY
WARNING:
ENABLE BATTERY
CALIBRATION?
NOTE: Press OK to enable
calibration and ignore for
normal charging. Message is
removed after 1 minutes.
MN002407A01-AK
Chapter 5: Charging Indication
LED Indicator
recommends removing from
fleet):
NOTE: Applicable on-
ly for APX NEXT XN
battery.
Flashing red
Flashing amber
LED Indicator
Green for approximately 1 sec-
ond
Battery requires Calibration,
but Calibration is disabled in
charger.
Alternating amber and green
for four seconds.
Steady red
27