Descargar Imprimir esta página

Motorola Solutions IMPRES 2 Guia Del Usuario página 29

Cargador para varias unidades
Ocultar thumbs Ver también para IMPRES 2:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 155
Table 10: Charging Indications for IMPRES 2 or IMPRES Battery (Calibration Required, but Not
Enabled)
Status
Charger Powers On
Battery Detected
Requesting IMPRES Battery
Calibration
Calibration is disabled in
charger.
Battery is charging.
Rapid Charging
Request for Calibration
timed out.
Charged to 90% or more
Charged to 95% or more
Fault
Standby
Battery is waiting to rapid
charge.
Battery is too hot, too
cold, or low voltage.
Charger is too hot.
Pocket Display
IMPRES 2
CHARGER
IMPRES 2
BATTERY
OR
IMPRES
BATTERY
WARNING:
ENABLE
BATTERY CALIBRATION?
NOTE: Press OK to enable
calibration and ignore for
normal charging. Message is
removed after 1 minutes.
RAPID CHARGE
xxxx0mAh yyy%Ptl
TRICKLE CHARGE
xxxx0mAh yyy%Ptl
CHARGE COMPLETE
xxxx0mAh yyy%Ptl
WARNING:
NOT CHRAGEABLE
REMOVE & REINSERT
WARNING:
HOT BATTERY
WAITING TO CHRGE
OR
COLD BATTERY
WAITING TO CHRGE
OR
VERY LOW BATTERY
WAITING TO CHRGE
OR
HOT CHARGER
WAITING TO CHRGE
MN002407A01-AK
Chapter 5: Charging Indication
LED Indicator
Green for approximately 1 sec-
ond
Battery requires Calibration,
but Calibration is disabled in
charger.
Alternating amber and green
for four seconds.
Steady red
Steady red
Flashing green
Alternating amber and green
Flashing red
Flashing amber
29

Publicidad

loading