Descargar Imprimir esta página

Motorola Solutions IMPRES 2 Guia Del Usuario página 37

Cargador para varias unidades
Ocultar thumbs Ver también para IMPRES 2:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 155
Chapter 6
Preparation for Lithium-Ion Battery
Shipment
You can prepare stand-alone IMPRES 2, IMPRES, or other authentic Motorola Solutions Lithium-Ion batteries
for shipment by air cargo using an IMPRES 2 Multi-Unit Charger. Other battery types are faulted. If the
IMPRES 2 Lithium-Ion battery is equipped with a Sleep mode, the charger puts the battery to sleep upon
completion of Ship Lithium charge.
Prepare only stand-alone Motorola Solutions Lithium-Ion batteries for shipment. Remove the battery from the
radio before placing it into the charger.
DO NOT store a stand-alone battery in the charger. When preparation for Lithium Shipment is complete,
immediately remove the stand-alone battery from the charger.
Selection of Lithium Shipment supersedes calibration or reconditioning.
6.1
IMPRES 2 or IMPRES Battery
Table 17: Status Indications of a Lithium-Ion Battery Prepared for Shipment (IMPRES 2 or IMPRES
Battery is due for Calibration)
Status
Charger Powers On
Battery Detected
Battery Discharging
Rapid Charging
Ship Lithium Complete
Fault
Battery is not making
proper electrical contact
with the charger.
Charger Display
IMPRES 2
CHARGER
IMPRES 2
BATTERY
OR
IMPRES
BATTERY
SHIP LI DISCHRGE
xxx% Rated Cap
SHIP LI CHARGE
xxx% Rated Cap
LI READY TO SHIP
xxx% Rated Cap
WARNING:
NOT CHARGEABLE
REMOVE & REINSERT
OR
WRONG BATT TYPE
Chapter 6: Preparation for Lithium-Ion Battery Shipment
LED Indicator
Green for approximately 1 sec-
ond
Battery requires calibration: Al-
ternating amber and green for
four seconds.
Steady amber
Steady red
Alternating amber and green.
Flashing red
MN002407A01-AK
37

Publicidad

loading