Publicidad
Idiomas disponibles
Idiomas disponibles
MN002407A01-AK
Chapter 5: Charging Indication
Table 11: Charging Indications for Fully Charged IMPRES 2 or IMPRES Battery (Calibration Required,
but Not Enabled)
Status
Charger Powers On
Battery Detected
Fault
Standby
●
Battery is waiting to rapid
charge.
●
Battery is too hot, too
cold, or low voltage.
●
Charger is too hot.
5.1
Charging Indications for Other Motorola Solutions
Batteries
Refer to the charging indications in the following table.
Table 12: Charging Indications for Other Motorola Solutions Batteries
Status
Charger Powers On
Battery Detected
30
Pocket Display
IMPRES 2
CHARGER
IMPRES 2
BATTERY
OR
IMPRES
BATTERY
WARNING:
NOT CHARGEABLE
REMOVE & REINSERT
WARNING:
HOT BATTERY
WAITING TO CHRGE
OR
COLD BATTERY
WAITING TO CHRGE
OR
VERY LOW BATTERY
WAITING TO CHRGE
OR
HOT CHARGER
WAITING TO CHRGE
Pocket Display
IMPRES 2
CHARGER
MOTOROLA SOLUTNS
LED Indicator
Green for approximately 1 sec-
ond
Battery requires Calibration,
but was fully charged within
the last 30 minutes, but cali-
bration is disabled in charge.
Alternating amber and green
for four seconds.
Flashing red
Flashing amber
LED Indicator
Green for approximately 1 sec-
ond
Steady red
Publicidad
