Motorola Solutions IMPRES 2 Guia Del Usuario página 41

Status
Standby
● Battery is waiting to rapid
charge.
● Battery is too hot, too
cold, or low voltage.
● Charger is too hot.
6.2
Other Motorola Solutions Batteries
Table 20: Status Indications of a Lithium-Ion Battery Prepared for Shipment (Other Motorola Solutions
Batteries)
Status
Charger Powers On
Battery Detected
Battery Discharging
Rapid Charging
Ship Lithium Complete
Fault
● Battery is not making
proper electrical contact
with the charger.
● Battery is unknown or
Nickel.
Charger Display
CANNOT SHIP LI
WARNING:
HOT BATTERY
WAITING TO CHRGE
OR
COLD BATTERY
WAITING TO CHRGE
OR
VERY LOW BATTERY
WAITING TO CHRGE
OR
HOT CHARGER
WAITING TO CHRGE
Charger Display
IMPRES 2
CHARGER
MOTOROLA SOLUTNS
BATTERY
SHIP LI DISCHARGE
xxx% Rated Cap
SHIP LI CHARGE
xxx% Rated Cap
LI READY TO SHIP
xxx% Rated Cap
WARNING:
NOT CHARGEABLE
REMOVE & REINSERT
OR
WRONG BATT TYPE
CANNOT SHIP LI
OR
Chapter 6: Preparation for Lithium-Ion Battery Shipment
LED Indicator
Flashing amber
LED Indicator
Green for approximately 1 sec-
ond
Steady amber
Steady amber
Steady red
Steady green
Flashing red
MN002407A01-AK
41