Motorola Solutions IMPRES 2 Guia Del Usuario página 32

MN002407A01-AK
Chapter 5: Charging Indication
Status
● Battery capacity is un-
known.
Charged
● Battery capacity is un-
known.
Fault
Standby
● Battery is waiting to rapid
charge.
● Battery is too hot, too
cold, or low voltage.
● Charger is too hot
5.3
IMPRES 2 or IMPRES Battery Long-Term Storage
You can prepare stand-alone authentic Motorola Solutions IMPRES 2 or IMPRES batteries (Lithium-Ion or
Nickel) for Long-Term Storage, in a suitable storage location, by using an IMPRES 2 Multi-Unit Charger.
Other battery types are faulted. If the IMPRES 2 battery is equipped with a Sleep mode, the charger puts the
battery to sleep upon completion of Long-Term Storage charge.
Prepare only the IMPRES 2 or IMPRES batteries for Long-Term Storage. Remove the battery from the radio
before placing it into the charger.
Do not store a stand-alone battery in the charger. When preparation for Long-Term Storage is complete,
immediately remove the standalone battery from the charger.
Selection of Long-Term Storage supersedes Calibration/Reconditioning. Lithium batteries prepared for Long-
Term Storage may not meet regulations for shipment by air cargo.
Table 14: Long-Term Storage Indications of an IMPRES 2 or IMPRES Battery (Battery is due for
Calibration)
Status
Charger Powers On
32
Pocket Display
CHARGE COMPLETE
WARNING:
NOT CHARGEABLE
REMOVE & REINSERT
WARNING:
HOT BATTERY
WAITING TO CHRGE
OR
COLD BATTERY
WAITING TO CHRGE
OR
VERY LOW BATTERY
WAITING TO CHRGE
OR
HOT CHARGER
WAITING TO CHRGE
Charger Display
IMPRES 2
CHARGER
LED Indicator
Steady green
Flashing red
Flashing amber
LED Indicator
Green for approximately 1 sec-
ond