Motorola Solutions IMPRES 2 Guia Del Usuario página 68

MN002407A01-AK
Chapter 16: Charger Troubleshooting
Chapter 16
Charger Troubleshooting
Table 25: Troubleshooting: Normal Charging
Problem
Charger powers On, but the LED does not flash
Green.
Battery inserted, but LED remains Off and display
does not identify battery.
Flashing red LED and display (if available) shows:
●
NOT CHARGEABLE
REMOVE& REINSERT
or
● UNKNOWN BATTERY (when a Motorola Solu-
tions battery is in the pocket)
Alternating red and green LED at the end of a
calibration.
Alternating amber and green LED for approximate-
ly four seconds at the battery insertion into the
charger.
In Analyzer mode, pocket 1 can display another
pocket.
68
What to do...
Make sure that the power cord is securely plugged
into the charger and an appropriate AC power out-
let. Ensure that there is power to the outlet.
Inspect fuses and replace as necessary.
If battery is inserted into any Pocket except Pocket
1, and if Power Saver is Enabled, then press the
Menu button.
● Remove the battery or radio from the pocket.
● Check electrical contacts on the battery and
in the charger pocket for contamination, corro-
sion, or physical damage.
● Verify that the battery is an authorized Motor-
ola Solutions battery. Other batteries may not
charge.
● Clean the battery electrical contacts using a
dry cloth.
● Remove power from the charger, then clean
the pocket electrical contacts using a dry cloth.
● Try replacing the battery. If the fault no longer
exists, take the faulted battery out of service.
● If the fault persists with the replacement bat-
tery, take the charger out of service.
The IMPRES 2 or IMPRES battery may be nearing
End of Service. The battery is usable, however the
available capacity may not be suited for heavy use
over an extended shift.
NOTE: For APX NEXT XN battery, the
battery has been exposed to cumulative
over temperature. Motorola Solutions rec-
ommends removing battery from service.
The IMPRES 2 or IMPRES battery requires Cal-
ibration/ Reconditioning. At the next available op-
portunity, place the battery into an IMPRES 2
charger that has Calibration enabled and allow the
charger to complete Calibration (solid green).
The charger is unable to detect the display on at
least one of the other pockets.