Publicidad
Idiomas disponibles
Idiomas disponibles
To carry out this operation, proceed as follows.
1 - Remove the burner cap (A) and the burner (B).
2 - Clean the burner and the flame cap thoroughly
and check that the holes in it are not blocked.
3 - Clean the ignition slot in the burner regularly.
4 - Clean the hob.
5 - After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
6 - Dry the surfaces and reassemble the compo-
nents. For correct burner assembly, follow the
instructions shown in the figure.
Caution - warning
Never pour water or allow dirt to fall into the
burner as this will cause the burner to mal-
function or block the nozzle.
To carry out this operation, proceed as fol-
lows.
1 - Switch the appliance off and leave it to cool.
2 - Turn off the circuit-breaker to disconnect it
from the electrical mains.
3 - Clean the interior of the hot cupboard of any en-
crustations which may affect its operation.
4 - Dry the surfaces off thoroughly.
IT
IT
GB
GB
DE
DE
To carry out this operation, proceed as follows.
FR
FR
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
ES
ES
panel (B).
4 - Undo the screw (D) of the pressure connection.
5 - Connect the pressure gauge (E) to the pressure
test point (F).
6 - Turn the gas supply tap back on.
7 - Light all the burners and turn the knobs to the full
flame setting (see page 9), then check that the
pressure reading complies with the values pro-
vided in the table (at the back of the manual.)
8 - Turn off the burners, disconnect the pressure
gauge and return all components to their initial
condition on completion of the operation.
English
CLEANING THE HOB, BURNERS AND ACCESSORIES
CLEANING THE HOT CUPBOARD
CHECKING GAS PRESSURE
C
A
B
C
- 12 -
A
B
IDM-39612100800.tif
IDM-3912500800.tif
E
IDM-39612100900.tif
F
D
Publicidad
