Publicidad
Idiomas disponibles
Idiomas disponibles
Baker GA 950 / GA 550
II. OPERATING INSTRUCTIONS
ELECTRICAL CONNECTION
Read the text below thoroughly before electrical connection.
The product is intended for connection to alternating current. The connection voltage (V) and frequency
(Hz) are shown on the name plate in the cabinet. Only the supplied cord is to be used.
Never use an extension cord for this appliance! If a wall socket is placed in a longer distance than the
length of the supplied power cord, contact an electrician to establish a wall socket within the range of the
supplied power cord.
If the product is defective, it must be examined by an authorized technician with proper knowledge of the
product during the guarantee period, if it is a product with built-in compressor. If it is a product connected to an
external compressor unit, it must be examined by the company who has connected the product to the unit.
Outside the guarantee period, it is advisable to use the service advised by your dealer. If this is not the case,
assistance is required from an authorized technician with proper knowledge of the product.
Always disconnect the power if interruptions in power supply occur,
and when electrical parts are removed/put on, and before cleaning and
maintenance of the product.
Repairing of electrical/technical parts may only be performed by
authorized technicians with proper knowledge of the product.
Do not use the product before all coverings are installed, so that live
or rotating machine parts can not be touched.
The product is not to be used outdoor.
All earthing requirements stipulated by the local electricity
authorities must be observed. The plug and wall socket should then
give correct earthing. If necessary, contact an electrician.
Make sure the product is switched off at the socket before
service is performed on electrical parts. It is not sufficient to
switch off the product by the START/STOP key as there will
still be voltage to some electrical parts of the product!
EN
6
Publicidad
