Cable Routing Diagram - Yamaha WR426F Manual De Servcio Del Propietario

EC240000

CABLE ROUTING DIAGRAM

1 Hose guide
2 Brake hose
3 Regulator
4 Fuel tank breather hose
5 Oil tank breather hose
6 Clamp
7 Sub wire harness
8 Tail light lead
9 TPS (throttle position sensor) lead
0 Neutral switch lead
A Oil hose
B Cylinder head breather hose
C Hose holder
D CDI magneto lead
E Clutch cable
F Decompression cable
G Lights switch lead
H Carburetor breather hose
I Overflow hose
J Coolant reservoir tank breather hose
CABLE ROUTING DIAGRAM
Å Pass the fuel tank breather
hose behind handlebar, then
insert it into the steering shaft
hole.
ı Pass
the decompression
cable, regulator lead and lights
switch lead under where the oil
hose is attached.
Ç Fasten the CDI magneto lead,
neutral switch lead and lights
switch lead to the frame with a
plastic locking tie.
Î Fasten the sub wire harness
and lights switch lead to the
frame in front of the protector
of the sub wire harness with a
plastic locking tie and cut off
the tie end.
2 - 38
SPEC
‰ Pass
the cylinder
breather hose along the right
side of the oil tank breather
hose.
Ï Fasten the sub wire harness
to the frame with a plastic
locking tie ends at the lower
left of the frame and cut off
the tie end. For fastening,
pass the plastic locking tie
through the upper holes in the
engine brackets.
Ì Pass the sub wire harness
between the engine brackets.
Ó Fasten the TPS lead (in the
sub wire harness) under the
frame so that it does not con-
tact the carburetor.
head