Cable Routing Diagram - Yamaha WR426F Manual De Servcio Del Propietario

EC240000

CABLE ROUTING DIAGRAM

1 Hose guide
2 Brake hose
3 Regulator
4 Fuel tank breather hose
5 Oil tank breather hose
6 Clamp
7 "ENGINE STOP" button lead
8 Sub wire harness
9 Tail light lead
0 TPS (throttle position sensor) lead
A Neutral switch lead
B Oil hose
C Cylinder head breather hose
D CDI magneto lead
E Hose holder
F Clutch cable
G Decompression cable
H Lights switch lead
I Carburetor breather hose
J Overflow hose
K Coolant reservoir tank breather hose
CABLE ROUTING DIAGRAM
Å Pass the fuel tank breather
hose behind handlebar, then
insert it into the steering shaft
hole.
ı Pass
the decompression
cable, "ENGINE STOP" but-
ton lead and lights switch lead
under where the oil hose is
attached.
Ç Fasten the CDI magneto lead,
neutral switch lead "ENGINE
STOP" button lead and lights
switch lead to the frame with a
plastic locking tie.
Î Pass the "ENGINE STOP" but-
ton lead and lights switch lead
along the inner side of the oil
tank breather hose.
2 - 38
SPEC
‰ Fasten the sub wire harness,
"ENGINE STOP" button lead
and lights switch lead to the
frame in front of the protector
of the sub wire harness with a
plastic locking tie and cut off
the tie end.
Ï Pass
the cylinder
breather hose along the right
side of the oil tank breather
hose.
Ì Fasten the sub wire harness
and "ENGINE STOP" button
lead to the frame with a plas-
tic locking tie and cut off the
tie end.
Ó Pass the sub wire harness
between the engine brackets.
head