Aqua SALT Cella 50 Manual De Instrucciones página 103

AQUA SALT
Salt chlorine generator
Flow filter
Indicates or sets the duration of flow
filter, i.e. the minimum time the flow
must be present to be recorded.
Cell type
Indicates or sets the cell type (50,
100, 150, 200).
Type of minerals
Indicates or sets the type of minerals
(Salt, Minerals).
Polarisation time
Indicates or sets the polarisation time
of the cell, i.e. the time for which the
polarity of the voltage sent to the cell
stays positive or negative.
Salinity
Set point
Indicates or sets the Set Point value
of salinity.
Proportional Range
Indicates or sets the value of salinity
proportional range.
Cycle period (minutes)
Indicates or sets the cycle period of
salinity correction, i.e. the sum of the
ON and OFF time of the pump.
 The TIMER tab programmes two kinds of timers: recirculation timers manage ignition and shut-down of
the recirculation pump; internal timers programme the ignition and shut-down of the chlorine generator, if
set on Internal timers mode.
Recirculation timer
Enabling
Indicates or sets the global enabling state of the 12
recirculation timers (On, Off).
1..12 Type
Identification Indicates or
number of sets the type
the of
Recirculation Recirculation
timer. timer (Off,
Mon-Fri,
Mon-Sun,
Sat-Sun).
 Through the ALARMS you can enable, disable and set the alarms you prefer.
Alarms enabling
Audible alarm enabling
Indicates or sets the enabling state of the audible
alarm (On, Off).
Recirculation pump state alarm enabling
Indicates or sets the enabling
"Recirculation pump state" alarm (On, Off).
Low production alarm enabling
Indicates or sets the enabling of the "Low production"
alarm (On, Off).
Insufficient production alarm enabling
Indicates or sets the enabling of the "Insufficient
production" alarm (On, Off).
ADSP7000648
LCD contrast
Indicates or sets the LCD contrast value.
LCD mode
Indicates or sets the work mode of the LCD display
(60 seconds ON, Always ON).
Clock type
Indicates or sets the clock type (12 or 24 hours)
Temperature unit
Indicates or sets the unit of measurement of
temperature (Celsius, Fahrenheit).
System unit
Indicates or sets the unit of measurement of pool
capacity (cu. m, imperial gallons)
Salinity unit
Indicates or sets the unit of measurement of salinity
(g/l, ppm).
Start Duration
Indicates or Indicates or
sets the sets the
time of duration of
activation of the
the recirculation
recirculation timer.
timer.
Cell Maintenance (hours)
Indicates or sets the duration of the Cell maintenance interval.
Cell Replacement (hours)
state of the Indicates or sets the duration of the life cycle of the cell.
Current alarm enabling
Indicates or sets the enabling of the "(low) voltage" alarm (On,
Off).
Temperature probe alarm enabling
Indicates or sets the enabling of the "Temperature probe" alarm
(On, Off).
rev. 1.4
MAINTENANCE AND INSTRUCTION MANUAL
Display
1..4 Type
Identification Indicates or
number of sets the type
the Internal of internal
timer. timer (Off,
Mon-Fri,
Mon-Sun,
Sat-Sun).
Electrolytic Cell Maintenance
31/07/2017
ENGLISH
Work mode
Indicates or sets the pH
work mode (Acid, Alkaline).
Proportional Range
Indicates or sets the value
of the pH proportional
range.
Cycle period (minutes)
Indicates the cycle period
of the pH correction, i.e.
the sum of the ON and
OFF time of the pump.
Timer
Start Duration
Indicates or Indicates
sets the time sets
of activation duration
of the the internal
internal timer.
timer.
103/264
103
or
the
of