AQUA SALT
Salt chlorine generator
Models available
pH electromagnetic pump output
Brine dosing electromagnetic pump output
Temperature sensor
Electrolytic cell self clearing
Replaceable electrolytic cell
Automatic chlorine regulation
Production based on temperature and UV rays
Superchlorination mode (boost)
Shutter mode
Winter mode (winter)
Password
RS232 serial connection
Bluetooth connection
Estimated useful life of the electrolytic cell
Flow sensor
pH reading and pH pump injection
Chlorine reading through AJ cell
Chlorine reading through Redox probe
3 Installation
3.1
Before installing the product, please read what this process will require and familiarize with the
components. This section provides all information required for a correct installation of the chlorine
Standard model
generator and its components.
installation
3.1.1
Follow these simple steps to install the electrolytic cell in your system.
Electrolytic Cell
Installation
ADSP7000648
Standard
5/7 years
Available
Not available
The installation
In vertical position, with an inclination below +/-15°.
Far from heat sources, in dry places, at a temperature
between 0 °C and 45°C.
In a ventilated location that can be easily accessed for
periodical maintenance.
Do not install the generator above the tank if you use liquids
that emit vapours, unless the tank is hermetically closed.
Keep the unit closed.
Installation and mounting instructions are the same for every
model.
It's strongly advised to use the grounding kit (optional) for the
protection of the measuring instruments and metal parts of
the pool installation
rev. 1.4
MAINTENANCE AND INSTRUCTION MANUAL
pH
pH/ClJ
5/7 years
5/7 years
Optional
General instructions
of the generator must be done as follows:
31/07/2017
ENGLISH
pH/Redox
5/7 years
64
64/264