Aqua SALT Cella 50 Manual De Instrucciones página 104

AQUA SALT
Salt chlorine generator
Excessive salt alarm enabling
Indicates or sets the enabling of the "Excessive salt"
alarm (On, Off).
Ice alarm enabling
Indicates or sets the enabling of the "Ice" alarm (On,
Off).
Chlorine OFA alarm enabling (minutes)
Indicates or sets the enabling of the "Chlorine OFA"
alarm, and the duration of the reference period, if any
(Off, 5...60 minutes).
pH OFA alarm enabling (minutes)
Indicates or sets the enabling of the "pH OFA" alarm,
and the duration of the reference period, if any (Off,
5...60 minutes).
 Through the PASSWORD tab, you will be able to set a new password and change the current one.
Old
Insert the current password in this field if you want to replace it with a new one.
New
Insert the new password in this field if you want to replace the current one.
 The SATURATION INDEX tab allows to calculate an index that describes the quality of pool water
pH
Indicates or sets the pH value to be used to calculate the Saturation Index (SI).
This value can be automatically acquired by the pH probe, if supported.
Total Alkalinity - TAC (ppm)
Sets the total alkalinity value of the pool water to be used to calculate the
saturation index (SI)
Calcium hardness - TH (ppm)
Sets the calcium hardness value of the pool water to be used to calculate the
saturation index (SI)
Temperature
Indicates or sets the temperature value to be used to calculate the Saturation
Index (SI). The temperature probe will read this value automatically.
SI
Press "SI calculation" to calculate the saturation Index (SI) derived from the
values specified in the above-mentioned four fields. The value indicates if the
water is in good conditions, corrosive or fouling.
 The AUTOMATIC READINGS/GRAPHS tabs make you read and visualize the values of the data
collected, both in graphs or tables.
Automatic Readings Settings
Range
Indicates the time interval between
the readings.
Automatic readings state
Indicates the state of the automatic
readings (Active, Not active). To
activate the automatic reading of the
values, press 'Start'. To interrupt or
pause the reading, press 'Stop'
ADSP7000648
Temperature probe alarm enabling
Indicates or sets the enabling of the "Temperature probe" alarm
(On, Off).
Temperature probe alarm enabling
Indicates or sets the enabling of the "Temperature probe" alarm
(On, Off).
Salinity OFA alarm enabling (minutes)
Indicates or sets the enabling of the "Salinity OFA" alarm, and
the duration of the reference period, if any (Off, 5...60 minutes).
pH level alarm enabling
Indicates or sets the enabling of the "pH level" alarm (On, Off).
Password
Saturation Index (SI) calculation
Graph settings
Elements
The check boxes of this section
make you select the values to
be visualized in the graph, or to
be exported in a .csv file.
Period
The fields of this section specify
the time lapse to examine the
magnitudes that have to be
visualized in the graph
exported in a .csv file.
rev. 1.4
MAINTENANCE AND INSTRUCTION MANUAL
Graph
Graphically Visualizes in a table
visualizes the trend the
of the selected selected values over
values over time. time.
or
31/07/2017
ENGLISH
104
Data
trend of the
104/264