Aqua SALT Cella 50 Manual De Instrucciones página 54

AQUA SALT
Salt chlorine generator
This section outlines the procedure to quickly programme the INTERNAL TIMERS mode of your chlorine
generator.
AQUA SALT KEYPAD
1 Switch on or off your AQUA SALT with the ON/OFF key.
Press and hold Enter You will switch to the Password Menu.
2
Default password: 0000  Press and hold Enter  You will switch to the Installer Menu.
3
4 Press F to scroll the Menu down to Pool Settings.
5 Press Enter to access the submenu.
6 Press F to scroll down to Pool Capacity.
7 Insert the capacity of your pool using UP or Down.
8 Press F to confirm and scroll down to Generator Operation.
9 Scroll with UP or Down and select Internal Timers.
10 Press and hold Enter to save the modifications and go back to the Installer Menu.
Press F to scroll down to System Settings  Press Enter to access the submenu.
11
12 Press F to scroll down to Cell Type.
13 Select the dimensions of the installed cells using UP or Down.
14 Press and hold Enter to save the modifications and go back to the Installer Menu.
Press F to scroll down to Programming Press Enter to access the submenu.
15
16 Insert the desired percentage of chlorine production using Up and Down.
17 Press F to confirm and scroll down to Cycle Time.
18 Set the desired Cycle Time with Up and Down.
19 Press and hold Enter to save the modifications and go back to the Installer Menu.
Press F to scroll down to Timer Press Enter to access the submenu.
20
Select the type of timer with Up and Down  Press F to confirm and move to the following line
21
22 Set the start time with Up and Down Press Enter to confirm the hours and move to the minutes.
Press F to move to the following section Use Up and Down to set the duration Press Enter to
23
confirm
24 Press and hold Enter to go back to the Timer Menu Press and hold Enter to go back to the Installer
Menu.
EXAMPLE: Base Chlorine= 50% ; Cycle time=1 hour; Timer type: MON-FRI; Start = 11:00; Duration = 3
hours; Timer type: SAT-SUN; Start = 09:00; Duration =10 hours
EXPLANATION: From 11:00 to 14:00 Monday to Friday and from 09:00 to 19:00 on Saturdays and Sundays,
chlorine is produced as follows: for 30 minutes (50% of an hour) the device generates chlorine, and for 30
minutes chlorine generation stops. Repeat steps 21 to 23 for each timer you need to programme.
ADSP7000648
AQUA SALT - INTERNAL TIMERS operating mode
Use this mode when you need to switch the generator on or off
at set times. Set one or more timers and the percentage of
chlorine you prefer. Chlorine is not produced outside the set
time. When at least one timer activates, chlorine is produced
following
percentage and cycle time. You can programme up to four
timers.
rev. 1.4
MAINTENANCE AND INSTRUCTION MANUAL
When to use INTERNAL TIMERS
ON/OFF cycles whose duration depends on
31/07/2017
ENGLISH
54/264