Aqua SALT Cella 50 Manual De Instrucciones página 72

AQUA SALT
Salt chlorine generator
The first section shows two columns: the left one shows the state of the device, the right one shows
the amount of chlorine generated (in mV or ppm) or the set chlorine percentage. You can modify the
% with the keys
are read-only. Possible state values are: Work, Work + Winter, Work+Shutter, Boost, Mixing(Mix),
Start-up (Up), Start-up + Winter, Start-up + Shutter as specified below:
Chlorine state
Indicates the pool water pH value between 0 and 14. This item is displayed only if the type of unit
pH
includes the presence of the pH probe.
The field indicates the Rx value measured in the pool water, expressed in mV. This item is displayed
Rx
only if the type of unit includes the presence of Rx probe.
Indicates the value of the chlorine in the pool water measured, expressed in ppm. This item is
Chlor
displayed only if the type of unit includes the presence of chlorine Jumo probe.
A countdown timer that indicates the time left for the current work phase is visualized.
time left
The left column shows the current phase of the device, and the right one shows the clock or the
remaining time. The clock shows the current time and it is shown during the following phases:
clock phase
time left phase The value of the remaining time decreases with the time, and it regards the following phases:
polarisation time
The polarisation time
The left column shows the
indicates the
value of the voltage; The right
frequency at which
column shows value of the
the electrodes switch
current.
their polarity.
Indicates current pool
water temperature.
Indicates the current amount of
salt in the water. This value is
Temperature
an estimate.
You will visualize a timer that shows the hour, minutes and seconds left before the next check of the
Cell check
electrolytic cell.
ADSP7000648
only if the state is Work, Start-Up and if the shutter is open. Ppm or mV values
 Work: the device is generating chlorine following the chosen operating mode.
 Work + Winter: the device is generating chlorine at a reduced operating mode according
to the percentage set.
 Work + Shutter: the device is generating chlorine, and the shutter is closed
 Boost: the generator is producing chlorine at 100% of its capacity (superchlorination)
 Mixing (Mix): the generator is mixing and it is not generating chlorine.
 Start-up (Up): the device is generating chlorine and switching electrode polarity every 2
hours for the set time.
 Start-up + Winter: the generator produces chlorine at a reduced operating mode due to
Winter mode, and switches electrode polarity every 2 hours for the set time.
 Start-up + Shutter: the generator produces chlorine at a reduced operating mode due to
the Shutter presence, and switches electrode polarity every 2 hours for the set time.

Pause.

Wait timer.

Wait flow.

Flow stabilization.

Work on.

Work off.

Clean.
VOut IOut
Instant salinity
estimeted
rev. 1.4
MAINTENANCE AND INSTRUCTION MANUAL
estimated
chlorine
generation (g/h)
Indicates the amount
chlorine generated in one hour.
This amount is an estimate.
average salinity
estimated
Indicates the average value of
salinity in the pool. This value
can be reset and recalculated
by pressing Enter.
31/07/2017
generator
operation
This section indicates
operating mode
among "Internal timers","
of
External timer", "Proportional".
flow
This section indicates if water
flows within the electrolytic cell
or not.
ENGLISH
72
the
chosen,
72/264