System Settings Menu - Aqua SALT Cella 50 Manual De Instrucciones

AQUA SALT
Salt chlorine generator
Sets a programmable time from 1 to 12 hours after which chlorine generator will decrease from
50% to 10% of the initial value gradually within 24 hours. (see Special modes paragraph 2.3).
Cover filter
Default value: 3 hours.
This menu manages the general operation settings of the chlorine generator, like unit of measurement of
4.5.2
temperature and salinity, current date and time, clock type and others.
System 
Press and hold Enter for more than 1 second to go back to the System Settings section of the
settings
Installer Menu.
menu
It allows you to set the system back to the initial conditions with the default programming
Reset parameters
parameters shown in Annex D.
Press Enter
Language
Allows you to set a four-
character password.
Allows you to choose the
Press Enter to confirm the
language
character and move to the
next one.
Indicates the dimensions of the titanium plates inside the electrolytic cell among the following
Cell type
four: 50/100/150/200
Indicates
percentage of the display of
the user interface.
Choose the temperature unit between Celsius or Fahrenheit
Temperature unit
System unit Sets the reference measurement system between Metric or English
Choose the salinity unit between g/l or ppm
Salinity unit
ADSP7000648
Salinity
unit
System
unit
Reset parameters
Confirm? Yes/No
temperature
unit
Clock Type
LCD Mode
Set password
LCD contrast
the contrast
rev. 1.4
MAINTENANCE AND INSTRUCTION MANUAL
Restore
Parameters
Language
Set password
Enter
Cell Type
LCD
Contrast
Date
Allows you to set the date
with the format:
Mon...Sun DD/MM/YY
Press Enter to confirm the
character and move to the
next one
LCD mode
Sets the backlighting of the
LCD display to:
Always on/60 seconds on
31/07/2017
Date
Time
Time
Allows you to set the time with
the format:
HH/MM
Press Enter to confirm the
character and move to the
next one.
Clock type
Choose the clock format:
12 /24 hours
ENGLISH
77
77/264