Troubleshooting; Troubleshooting Table - Invacare Stand Assist Manual Del Usuario

7 Troubleshooting

7.1 Troubleshooting Table

SYMPTOMS
Noisy or dry sound from pivots.
Electric actuator fails to lift when button
is pressed.
Unusual noise from lift arm actuator.
Lift arms will not lower in uppermost
position.
Legs do not open and close properly.
If problems are not remedied by the suggested means, please contact your dealer or Invacare.
1078985-K
FAULTS
Needs lubrication.
Hand-control or actuator connector
loose.
Battery low.
RED emergency stop button pressed IN.
Battery not connected properly to
control box.
The connecting terminals are damaged.
Electric actuator in need of service or
load is too high.
Actuator is worn or damaged or spindle
is bent.
Lift arms require a minimum weight load
to lower from the uppermost position.
Base may require adjustment.
SOLUTION
Refer to Lubricating the Lift .
Connect hand control or actuator
connector. Ensure connectors are seated
properly and fully connected.
Charge batteries. Refer to 4.7 Charging
the Battery, page 10.
Rotate RED emergency stop button
CLOCKWISE until it pops out.
Reconnect the battery to the control
box. Refer to 4.7 Charging the Battery,
page 10.
Replace the battery pack. Refer to 4.7
Charging the Battery, page 10.
Refer to 8.7 Replacing the Electric
Actuator, page 19. Contact your Dealer
or Invacare representative.
Refer to 8.7 Replacing the Electric
Actuator, page 19. Contact your Dealer
or Invacare representative.
Pull down slightly on the lift arms.
Refer to 8.6 Adjusting the Base, page 19.
Troubleshooting
17