What To Do If Trouble Occurs - GUTMANN VIENTO Instrucciones De Uso

EN

6 What to do if trouble occurs?

Interference with and repairs to the appli-
ance by unqualified persons are dangerous
as they can result in an electric shock or a
short circuit. Do not interfere with or try to
repair the appliance; this could cause injury
to persons and damage to the appliance.
Always have such work done by an expert,
e.g. a Customer Service technician.
Please note
If your appliance is faulty, please check
•
whether you can rectify the problem your-
self by consulting these instructions for
use.
You may be able to rectify some prob-
lems yourself. They are described be-
low.
The fuses blow regularly?
Contact a technical customer service or
•
an electrician!
Does the hob have tears or cracks?
There is a risk of electric shocks if the
•
glass ceramic hob develops fractures,
cracks, tears or damage of any other
kind. Immediately switch off the appli-
ance.
Disconnect the fuse immediately and call
•
Customer Service.
You can't switch your induction hob on?
Has the wiring system (fuse box) in the
•
house blown a fuse?
Has the hob been connected to the
•
mains?
Is the childproof lock activated, i.e. does
•
the display show an " ?
Are the sensor keys partly covered by a
•
damp cloth, fluid or a metallic object?
Please rectify.
Are you using unsuitable cookware? See
•
the section on Cookware for induction
hobs.
The hob or a cooking zone has suddenly
switched off
Did you accidentally press the ON/OFF key?
•
Are the sensor keys partly covered by a
•
damp cloth, fluid or a metallic object? A
buzzer will sound briefly.
66
GENERAL TOPICS
•
•
•
The pot sign
•
The pot sign
a pot orpan was placed on the hob?
•
LED display for cooking settings and re-
sidual heat display H does not come on
or only partially.
•
The symbol
time-limited
sound.
•
Error code E2 is indicated?
•
•
Error code E8 is indicated?
•
•
After a few seconds the appliance will
switch off.
Please remove the item located in front of
the sensor keys.
Has the safety cut-off device been acti-
vated, i.e. was a power level operated
unchanged beyond a specific period of ti-
me? See the section on operation time li-
mit.
appears?
A cooking zone has been switched on
and the hob is expecting a suitable pot or
pan to be placed on the cooking zone
(pan recognition). Only when a pot has
been placed on the cooking zone will
power be supplied.
still appears, even though
The cookware is unsuitable for induction
cooking or the pot or pan is too small.
Display defective. Call Customer Service.
Risk of burning, as the temperature warn-
ing is not guaranteed.
or ER03 will blink and a
¯
continuous
Food which has boiled over, cookware or
other items are causing the touch control
sensor keys to be consistently operated.
Remedy: clean the surface or remove the
item. To delete the symbol press the sa-
me key or switch the hob off and on.
The electronic unit is too hot. Check the
installation of the hob. Make sure that
there is sufficient ventilation. See the sec-
tion on "Protection against overheating".
Do not heat-up empty pots and use ap-
propriate cookware.
Fault on the left or right hob fan. The suc-
tion opening is blocked or covered or the
fan is defect.
Check the installation of the hob. Make
sure that there is sufficient ventilation.
signal will