Cleaning The Metal Grease Filter - GUTMANN VIENTO Instrucciones De Uso

EN
SERVICE INSTRUCTIONS

Cleaning the metal grease filter

Rinse the filter cassette regularly (every 14 days) or if necessary under hot
water .Metal grease filters can be cleaned in the dishwasher.
After approx. 40 operating hours, the grease-filter-saturation-display flashes .
( see Chapter 4.30 Page 63 )
The manufacturer does not accept any liability for possible discolouration
caused by the use of aggressive detergents.
Caution: Do not use multi-phase cleaners. Do not clean the filter in a commercial
dishwasher. Cleaning with aggressive cleaning agents such as petrol, acetone, trichloro-
ethylene, etc. can cause damage !
Cyclic change of the activated carbon fine dust filter
As cleaning is not possible, it should be replaced after 120-200 operating
hours or in four-month cycles. There is a need for premature replacement if
the cleaning performance of the filter decreases ( noticeable by the fact that
the extractor hood no longer provides the full extraction performance, or the
room air quality is no longer acceptable ) .
Remove the activated carbon filter as illustrated and dispose of in accordance with local re-
gulations. No regeneration possible !
Insert filter
Insert the cleaned grease
filter and activated char-
coal filter in the filter cas-
Metal - grease-filter
sette.
Charcoal filter
First insert the active char-
coal filter (thin) and then
the metal grease filter
(thick) over it.
Then insert the filter cas-
sette into the filter trough.
Finally place the filter cover
over it.
Cleaning air outlet strips
To clean, push backward and lift - clean - then reinsert - push forward until you feel it snap-
ping in. Attention: Do not clean in the dishwasher !
73