Operating The Keys; Switching On The Hob And Cooking Zones; Switching Off A Cooking Zone - GUTMANN VIENTO Instrucciones De Uso

EN
52
OPERATION MANUAL

4.10 Operating the keys

4.11 Switching on the hob and cooking zones

1. Press the ON/OFF key (approx. 1 sec.) until the
2. Put cookware suitable for induction cooking on-
3. Use the Power setting display (as a key) to sel-
4. The slider control must be activated immedia-

4.12 Switching off a cooking zone

5.a)
5.b)
5.c)
The controls described here expect the pressing
of a (selection) key to be followed by the pres-
sing of a subsequent key. The next key will
need to be pressed within 10 seconds, otherwi-
se the selection will be deleted.
power setting 0 appears and a short signal will
sound. The controls are ready for operation.
to the cooking zone. The pan recognition device
will activate the induction coil. Power setting dis-
play of the corresponding cooking zone shows
"0".
ect a cooking zone. The stand-by dot of the coo-
king zone selected will light up.
tely afterwards. A power setting will be switched
on.
left - Power setting 0
center - Power setting 6
right - Power setting P
See the section on worth
knowing about the slider (sensor field).
Press the respective sensor field
power setting or to switch on an additional coo-
king zone.
Important: the stand-by dot of the cooking zone
selected must light up.
As long as no cooking pot is placed onto the
cooking zone, the display will alternate between
the power level set and the symbol . If no pot is
placed on the cooking zone, it will switch off af-
ter 10 minutes for reasons of safety. Please re-
fer to the Section on pan recognition.
Use the power setting display (as a key) to sel-
ect a cooking zone. The stand-by dot of the coo-
king zone selected must light up.
Press the slider area on the far left or
drag your finger to the left across the slider
control to reduce the power setting to 0
Press the ON/OFF key. All the cooking zones
are switched off.
to change a