Switching Off The Hob; Pause Function; Recall Function - GUTMANN VIENTO Instrucciones De Uso

OPERATION MANUAL

4.13 Switching off the hob

6.
-
-
-

4.14 Pause function

1. Pots and pans are on the cooking zones and the
2. Press the Pause key "II". Instead of the selected
3. The interruption is ended by firstly pressing the

4.15 Recall function

1. The hob is inadvertently turned off by the ON/
2. Within 6 seconds after turning it off, press the
What can be restored:
-
-
-
-
-
Not to be restored:
-
Press the ON/Off key of the hob . The hob will be
switched off , irrespective of any settings.
Please note:
The hob will switch off automatically after 10 sec-
onds when all the cooking zones are switched of
manually (power setting 0) and no key/sensor
field is pressed afterwards.
The Power boost function is activated immediate-
ly. See the section
Fan has an after run function
(see chapter 4.28 Fan after run)
The cooking process can be briefly interrupted
with the Pause function, e.g. if the doorbell rings.
The Pause function must be released in order to
continue cooking at the same power level. If a
timer has been set it will pause and will then con-
tinue.
This function is only available for 10 minutes for
reasons of safety. The hob will then be switched off.
required power levels have been set.
power settings, the interval sign "II" will light up
Pause key "II" and then pressing any other key
(except the ON/ OFF key).
Notes:
The pause symbol "II" also appears on the fan
display when the pause is active. The fan level (if
greater 0) is reduced to level 1.
(recovery function)
The most recent setting can be recovered if the
hob is switched off unintentionally.
The recall function only works if at least one coo-
king zone is switched on.
OFF key of the hob.
ON/OFF key of the hob again.
The Pause key blinks.
The Pause key must be pressed immediately af-
terwards.
The original cooking levels are restored. The
cooking process continues.
Cooking levels of all cooking zones
Fan level
Minutes and seconds of programmed timer func-
tions
Automatic boost function
Power boost
Operation time limit (it is counted from 0)
EN
on Power setting.
53