Maintenance; Table Of Regular Maintenance; Cleaning - Mercury 7070 PROOF Manual De Instrucciones Para Uso Y Mantenimiento

Problem
Backrest cannot be
adjusted
Backrest and footrest tend
to jump out of position
The legs cannot be
released
Side ;pieces cannot be
blocked
The wheels do not move
The braking system is not
effective
The load bearing trolley
does not remain horizontal
Broken rigid platform

5. MAINTENANCE

5.1. TABLE OF REGULAR MAINTENANCE

To maintain the product in perfect working order and keep it so for the entire period of the guarantee, it is necessary to carry out regular
maintenance. It is recommended that the work carried out be recorded on the appropriate page of this manual (§ 5.4)
Whenever any irregularity in an original product is identified, the product should immediately be taken out of
service, until the damaged component is repaired or replaced
The schedule of normal maintenance depends on the frequency of use of the product; the table sets out the factors that should be
taken into consideration:
General inspection and correct working of the
various devices (§ 4.3.)
Cleaning (see next point )
Check the tightness of all screws
Lubrication (see next point )
Inappropriate use and maintenance may cause damage to persons and things. Carry out regular
maintenance as indicated in the manual. For assistance and replacement parts apply exclusively to
ME.BER.
To maintain the efficiency of the appliance, we recommend the purchase of our technical assistance packs "Me.Ber. Security Plan".

5.2. CLEANING

CLEANING and DISINFECTION must be carried out AFTER USE
Metallic parts:
Plastic parts:
MERCURY
Probable causes
Defective cylinder rod
Control lever not properly fixed
Defective component in the
kinematic chain of the mechanism
Broken spring
Worn cast
Broken bearing
Wheels tightened excessively
Broken friction pad
Broken spring/s
Heavy blow
Type of action
Wash and disinfect using a sponge soaked in water and
Replace the entire assembly (contact ME.BER. Technical
Assistance)
Remove the upper bolt that secures the gas spring; rotate the
control lever clockwise twice through 360 degrees; screw in the
fixing nut and reassemble
Replace the defective component (contact ME.BER. Technical
Assistance)
Replace spring (contact ME.BER. Technical Assistance)
Replace cast (contact ME.BER. Technical Assistance)
Replace bearing (contact ME.BER. Technical Assistance)
Slacken the wheels by unscrewing them a couple of turns.
Remove the wheel and replace the friction pad after tightening
the fixing screw
Proceed in this order: unscrew the bolts that hold in place the
pin; unscrew the two small levers; take out the two pins;
remove and replace the spring/s.
Replace the platform (contact ME.BER. Technical Assistance)
Frequency (uses/ month)
 50
6 months
CLEANING and DISINFECTION must be
carried out after use
6 months
6 months
disinfectant. Rinse and dry well.
36
Solutions
50 ÷ 200 > 200
3 months 1 month
3 months 1 month
3 months 1 month
Rev.08 140722