Tools And Equipment; Additional Material Considerations; Mounting Pole - Phoenix Contact UM IA RAD-SOL-SET-24 Serie Manual De Instrucciones

7150_ia_05
4.3

Tools and equipment

No tools are supplied with the RAD-SOL-SET-24-... solar system. However, we suggest
that you have the following tools to ensure a successful installation.
– Compass
– Flat-blade screwdriver set
– Philips screwdriver set
– Diagonal cutter
– Cable knife
– Crimping tool
– Multimeter
– Open-ended wrench set (standard)
– Ferrule set (standard)
– Crimping pliers
– Additional accessories
4.4

Additional material considerations

The following is a list of materials you may need to complete the installation and to operate
the system (see "Ordering data for accessories" on page 10-4).
– Mounting pole (e.g., sign mast 76 mm in diameter),
suitable for mounting the antenna, solar panel, and control cabinet
– Antenna
– Antenna cable
– Adapter cable
– Connection of external sensors, switching devices, etc.
– Radios
– UV-stabilized cable binders
4.5

Mounting pole

To accommodate the module mounting bracket, the mounting pole to which the
RAD-SOL-SET-24-... solar system is secured must have an outside diameter of 76 mm (for
installation example, see Figure 4-2). In addition, the pole must accommodate an antenna
and the control cabinet of the solar system. Dimensions for the solar panels and control
cabinet can be found on page 10-3 of this manual.
The plant installation engineer is responsible for the correct assembly and installation of
the solar system.
The plant operator is responsible for selecting the location (e.g., water protection area).
The relevant regional regulations must be observed.
Installation
4-3
PHOENIX CONTACT