Installing Surge Protection For Antenna Cables - Phoenix Contact UM IA RAD-SOL-SET-24 Serie Manual De Instrucciones

7150_ia_05
4.9

Installing surge protection for antenna cables

Your solar system includes surge protection for protecting the radio module and electronics
in the control cabinet.
When fitting the surge protection, follow these steps:
1. Locate the hole seal on the lower shelf of the control cabinet and remove it (see
Figure 4-7, A).
2. Install a ground wire (1.5 to 2.5 mm
terminal.
3. Install the surge protection and tighten the lock nut.
Key for Figure 4-7:
1 Hexagonal nut, M20
2 Closed self-sealing grommet, M20
3 Ground wire, 1.5 to 2.5 mm
2
4 Wire lug, 1.5 to 2.5 mm
5 Nut (1 x)
6 Screw
7 Retaining washer
2
8 Cable lug, 1.5 mm to 2.5 mm
9 Surge protector
10 Lower shelf of the control cabinet
11 Retaining washer
12 Hexagonal nut, M20
13 Earth-ground wire lug, 16 mm
supply)
14 Nut
15 Functional earth ground (FE), cable 16 mm
2
) between the surge protector and earth ground
2
2
2
for M6 threaded bolts (not included in the scope of
2
(not included in the scope of supply)
Installation
4-13
PHOENIX CONTACT