Phoenix Contact UM IA RAD-SOL-SET-24 Serie Manual De Instrucciones página 136

RAD-SOL-SET-24-...
4-28
PHOENIX CONTACT
3. Open the required opening in the connection space.
4. Assemble the cable feed-through at the outlet box.
5. Trim the solar cable to the required length.
6. Guide the solar cable from the control cabinet through the cable routing of the solar
paneloutlet box.
7. Attach a crimping wire lug to the end of the cable.
8. Connect the solar cable to the required connection terminal block (observe polarity).
Solar cable (negative pole)
9. Repeat this with the second solar cable on the second solar panel (observe polarity).
Connecting cable
10. Open a prepunched hole on each of the solar panel outlet boxes.
11. Fit a cable feed-through to each outlet box.
12. Guide the connecting cable into the outlet boxes.
13. Trim the connecting cable to the required length and attach wire lugs to the ends of the
cables.
Figure 4-17 Mounting cable feed-throughs
14. Tightly screw the cover onto the outlet box.
15. Tighten all locking screws of the cable routings to ensure reliable strain relief and
watertight cable feed-through.
7150A034
7150_ia_05