Phoenix Contact UM IA RAD-SOL-SET-24 Serie Manual De Instrucciones página 113

7150_ia_05
Figure 4-3 shows a wiring diagram with the solar system components. The mounting
system enables both pole and wall mounting (see Figure 4-4 on page 4-8).
WARNING: Fall hazard
When using climbing and assembly aids, such as ladders or raised platforms, the relevant
safety regulations must be observed. The climbing and assembly aids must not be braced
on the control cabinet.
Always ensure that they are stable.
There is one mounting flange each at the top and bottom of the control cabinet, via which
the cabinet can be attached to the mounting pole using two pole brackets with 76 mm
diameter.
The control cabinet should be mounted directly below the solar panel bracket, so that it is
shaded by the solar panel at noon in the summer months.
For protection against unauthorized access, the control cabinet should be fitted with two
locking devices. These locking devices can also be secured with padlocks (7 mm and
9 mm diameter locking arm).
Installation
4-5
PHOENIX CONTACT