RAD-SOL-SET-24-...
4-4
PHOENIX CONTACT
4.6
Installing the control cabinet
The batteries and electronics panel control cabinet is suitable for outdoor use. To ventilate
the control cabinet, the control cabinet door is fitted with vents and a filter matt cartridge in
the factory.
Depending on the selected usage location of the solar system, the vents may need to be
sealed off. If this is necessary, use the RAD-SOL-VENT-COVER cover plate (see chapter
10.2.2 on page 10-4).
How to seal the vents:
1.
Use a suitable tool to remove the four lock nuts of the filter matt cartridge.
2.
Remove the filter matt cartridge from the threaded bolts.
3.
Align and then slide the cover plate with integrated gasket onto the threaded bolts.
4.
Attach the cover plate using the four lock nuts.
Figure 4-1
Fitting the cover plate
7150A036
7150_ia_05