Charge Controller - Phoenix Contact UM IA RAD-SOL-SET-24 Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8

Charge controller

7150_ia_05
8.1
General
The SunSaver charge controller is a fully automated controller for photovoltaic systems. It
provides electronic protective functions for the controller and the solar panels. The batteries
are charged using an algorithm for pulse width modulation with constant voltage, which has
been optimized for photovoltaic systems.
S O L A R C O N T R O L L E R
Figure 8-1
SunSaver charge controller
Key:
1
Green "CHARGING" LED (charging the batteries)
2
Red "LOAD DISCONNECT" LED (load disconnection due to insufficient battery
voltage)
3
Terminal connections [3] and [4] for the solar panels
4
Terminal block connections [1] and [2] for the battery
5
Terminal block connections [5] and [6] for the loads
6
Terminal block jumper for setting the battery type (sealed battery or flooded battery)
NOTE: Damage to the batteries by removing the terminal block jumper
The solar system is supplied with two batteries (sealed battery).
To set the battery type when using this battery, the terminal block jumper [6] that is already
inserted must be left in the charge controller!
1
LOAD
CHARGING
DISCONNECT
TEMP Sense
SEALED
SOLAR
BATTERY
LOAD
OR
FLOODED
12 V
4
3
2
1
6
5
SELECT
+
-
+
-
+
-
3
4
5
6
Charge controller
2
Remove
Jumper
Wire for
Flooded
Battery
7150B032
8-1
PHOENIX CONTACT

Publicidad

Tabla de contenido
loading

Productos relacionados para Phoenix Contact UM IA RAD-SOL-SET-24 Serie

Tabla de contenido