Safety Instructions For Troubleshooting; Notes On Specific Hazards - Hupfer SPTW-2/EBF/TEHCO Manual De Instrucciones

Safety Instructions

Safety Instructions for Troubleshooting

2.6 Safety Instructions for Troubleshooting
The following points must be observed when carrying out any troubleshooting operations:
§
The local applicable Accident Prevention Regulations must be observed.
§
Take the food transport trolley out of operation before beginning maintenance or repair work. Switch
off the food transport trolley with the On / Off switch, pull out the mains plug, insert it into the plug park
provided and secure to prevent unauthorized reactivation. Before beginning work on the electrical
system, isolate the appliance from the mains supply and secure to prevent it being switched on again.
This work must only be carried out by a certified electrician.
§
Observe the valid product safety regulations when handling oils, greases and other chemical sub-
stances.
§
Carry out all the checks and inspections of the appliance on a regular basis. Remedy immediately de-
ficiencies, such as loose screw connections, melted or damaged leads.
§
Only authorised specialists may perform all repair work.
§
Defective components should only be replaced with original parts.
2.7

Notes on Specific Hazards

Electrical energy
§
All work on the electrical installations should only be carried out by a certified electrician or by author-
ised specialists under supervision and monitoring of a certified electrician according to the applicable
electro-technical regulations.
§
The appliances on which inspection, maintenance and troubleshooting work is performed must be
disconnected from the power supply and secured against reactivation when the voltage is not re-
quired for this kind of work. This must only be carried out by a certified electrician.
91319926_A0
Chapter 2
Page 11
Food transport trolley
SPTW-2/EBF/TEHCO