Important Safety Instructions - JUKI HZL-G serie Manual De Instrucciones

Ocultar thumbs Ver también para HZL-G serie:
Tabla de contenido

Publicidad

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic safety precautions should always be followed, including the following:
Read all instructions before using this sewing machine.
DANGER
-To reduce the risk of electric shock:
1. An appliance should never be left unattended when plugged in.
2. Always unplug this appliance from the electric outlet immediately after using and before cleaning.
WARNING
-To reduce the risk of burns, re, electric shock, or inquiry to persons:
1. Do not allow this appliance to be used as a toy. Close attention is necessary when this appliance is used by or near
children.
2. Use this appliance only for its intended use as described in this manual. Use only attachments recommended by the
manufacturer as contained in this manual.
3. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or
damaged, or dropped into water. Return the appliance to the nearest authorized dealer or service center for examination,
repair, electrical or mechanical adjustment.
4. Never operate the appliance with any air openings blocked. Keep ventilation openings of the sewing machine and foot
controller free from the accumulation of lint, dust and loose cloth.
5. Keep ngers away from all moving parts. Special care is required around the sewing machine needle.
6. Always use the proper throat plate. The wrong plate can cause the needle to break.
7. Do not use bent needles.
8. Do not pull or push fabric while stitching. It may deect the needle causing it to break.
9. Switch the sewing machine off ("O") when making any adjustments in the needle area, such as threading needle,
changing needle, threading bobbin, or changing presser foot and the like.
10. Always unplug sewing machine from the electrical outlet when removing covers, lubricating, or when making any other
user servicing adjustments mentioned in the instruction manual.
11. Never drop or insert any object into any opening.
12. Do not use outdoors.
13. Do not operate where aerosol (spray) products are being used or when oxygen is being administered.
14. To disconnect, turn all controls to the off ("O") position, then remove plug from outlet.
15. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
SAVE THESE INSTRUCTIONS
This sewing machine is intended for household use only.
Foot controller: Model JC-001
Foot controller can be used on sewing machine model HZL-G210 or HZL-G110.
The working temperature of sewing machine is from 5 to 40 degree Celsius. Do not use sewing machine under direct
sunlight, near a heat source such as stove, iron, candle or any hot objects and in the place where temperature is high.
Otherwise temperature inside sewing machine becomes high and/or vinyl of the power cord may be damaged, resulting in
re or an electric shock.
Always check a combination of material, thread and needle size. (Refer to page 43.) If the combination is not right, for exam-
ple, sewing thick material such as denim with thin needle like size 11 and smaller, needle may break and it will cause injury to
your body.
1

Publicidad

Tabla de contenido
loading

Tabla de contenido