Assembly - Tunturi E60 Manual Del Usuario

cord does not run underneath the equipment.
• Do not alter (for example lengthen) the cord between
the transformer and the unit.
NOTE ABOUT ASSEMBLING THE EQUIPMENT
Start by unpacking the equipment. The detailed assembly
instructions can be found at the back of this guide. Follow
the instructions in given order.
Before assembly, check the contents of the package.
If a part is missing, please contact your dealer with the
model, equipment serial no. and spare part no. of the
missing part. You'll find a spare part list at the back of this
guide. The hardware kit contents are marked with * in the
spare parts list. The directions left, right, front and back
are defined as seen from the exercising position. Keep the
assembly tools, as you may need them e.g. for adjusting
the equipment. Note that two people are needed for the

assembly.

The packaging includes a silicate bag for absorbing
moisture during storage and transportation. Please dispose
of the bag once you have unpacked the equipment.
Allow at least 100 cm of clearance around the
equipment. We also recommend opening the package
and assembling the product on a protective base.
SAVE THIS INSTRUCTION MANUAL
ASSEMBLY
Start by unpacking the equipment and check that you
have the following parts:
1. Frame
2. Rear and front support
3. Pedals (2 pcs)
4. Handlebar
5. Console
6. Transformer
7. Assembly kit (contents marked with in the spare part
list): keep the assembly tools, as you may need them
e.g. for adjusting the equipment.
If necessary, please contact your dealer with the model,
equipment serial no. and spare part no. of the missing
part. You'll find a spare part list at the back of this guide.
The packaging includes a silicate bag for absorbing
moisture during storage and transportation. Please dispose
of the bag once you have unpacked the equipment. The
directions left, right, front and back are defined as seen
from the exercising position. We recommend that the
equipment is installed by two adults.
REAR AND FRONT SUPPORT
By holding on to the seat, incline the equipment
backwards so that it rests on its transportation wheels.
Attach the rear support from below with four hexagonal
socket head screws and washers. Attach the front support
to the frame with four screws and washers. Restore the
equipment to its upward position so that it rests on the
support feet.
PEDALS
The pedals are distinguished by the markings R (= right)
and L (= left) on their shafts. Fasten the right pedal to the
right pedal crank turning clockwise and the left pedal to
the left pedal crank turning counterclockwise. Fasten the
pedal bands first into the retainer at the device. Thread
the band through the pedal loop and push the band
opening into the projection in the pedal. Fasten the pedal
bands to the pedal outside. Push the band through the
locking buckle and the band locks automatically. The
length of the band can be adjusted with the locking
buckle.
HANDLEBAR
Attach the cable coming from the frame tube to the
connector at the bottom of the handlebar. Ensure that
the joint is securely locked by gently pulling the wire.
Thread the wire carefully inside the frame tube. Open the
handlebar locking knob by turning it anticlockwise a few
times and then pulling it outwards. Insert the handlebar
into the front frame tube. Release the locking knob once
the handlebar has reached the required level. Ensure that
the handlebar is locked. Secure and tighten the locking
knob by turning it clockwise.
3
E60 - OWNER'S MANUAL ENGLISH