Operating Lever Controls (W.o./ Silo Bucket And Milling Machine); Operating Lever Controls (With Silo Bucket And Milling Machine) - Nogueira VMN 4.0 Manual De Instrucciones

Operating Lever Controls (w.o./ silo bucket and milling machine)

From the tractor operating controls, the operator can access all the operating controls and adjust the
components of the machine.
The machine (wagon) must be operated by only 01 (one) operator.
The hoses (fig.1) must be hooked up to the tractor hydraulic controls, thus all the necessary controls for
the wagon without the milling machine are directly connected to the tractor controls.
VERSION WITHOUT MILLING MACHINE (fig.2).
1- Hoses with fast connect fittings to hookup to
the tractor hydraulic system.
fig.1
Operating Lever Controls (with/ silo bucket and milling machine)
From the tractor operating controls, the operator can access all
the operating controls and adjust the components of the
machine.
The machine (wagon) must be operated by only 01 (one)
operator.
While operating, the control levers must remain in the cabin, in
the appropriate control support (fig.3).
When disconnecting the wagon from the tractor, the control
hoses must be reinstalled to the wagon controls (fig.4).
fig.4
10
Instruction Manual
fig.3
fig.2