Changing The Milling Machine Blades - Nogueira VMN 4.0 Manual De Instrucciones

Changing the Milling Machine Blades

1) Raise the milling machine until the shoulder height of the operator (in order to work more
comfortably);
2) Close the discharge blocking valve, assembled on the left cylinder of the arm (A fig.1) and wear
appropriate personal protection equipment, such as footwear and cut resistant gloves;
3) Disconnect from the tractor;
4) Proceed in changing the blades;
5) Always change one blade at a time together with the fastening screws (3 fig.2), checking if they are in
the original position and direction, as displayed in the figure#4;
Remember to open the valve at the end of this procedure.
3
A A
open position closed position
valve for the milling machine arm
fig.2
fig.1
fig.4
34
Instruction Manual