Summarized Maintenance Table - Nogueira VMN 4.0 Manual De Instrucciones

Replace the blades when the blade profile is reduced by 4 mm.
b) The middle thread blades, if they are worn out, must be replaced in order to achieve good cutting
quality; verify if the distance of the counter-blades on the bottom of the bin is over +/- 2 mm.
An excessive space between the blades and the counter-blades worsens the cutting of the ingredients
notably and exerts more wear and tear on the machine.
WEAR APPROPRIATE PERSONAL PROTECTIVE EQUIPMENT TO PREVENT
ACCIDENT WHEN PERFORMING EACH MAINTENANCE PROCEDURE.

Summarized Maintenance Table

LUBRICATION
MAINTENANCE CYCLE
Mix in standard operating conditions up to 5 hours
per day with conventional ingredients
DOOR
OIL IN THE TRANSMISSION GEAR
OIL IN REDUCING THE DESENSILADOR
OIL IN THE HYDRAULIC SYSTEM
OIL FILTER CARTRIDGE IN THE TANK
PISTONS AND FULCRUM OF DESENSILADOR
CHAINS AND BEARINGS
CROSSPIECES OF CARDAN
TIRE NUTS
TENSION OF THE DISCHARGE CONVEYOR
KNIVES OF THE THREADS
OIL LEAKS
MAINTENANCE CYCLE
Mix operating in severe conditions up to 5 hours
with no conventional ingredients
DOOR
OIL IN THE TRANSMISSION GEAR
OIL IN REDUCING THE DESENSILADOR
OIL IN THE HYDRAULIC SYSTEM
OIL FILTER CARTRIDGE IN THE TANK
PISTONS AND FULCRUM OF DESENSILADOR
CHAINS AND BEARINGS
CROSSPIECES OF CARDAN
TIRE NUTS
TENSION OF THE DISCHARGE CONVEYOR
KNIVES OF THE THREADS
OIL LEAKS
26
CHANGE
After
After
the first
the first
10 hours
100 hours
After
After
the first
the first
10 hours
100 hours
Instruction Manual
CONTROL
HOUR INTERVAL
or every month
HOUR INTERVAL
or every month
or every year
or every year