Adjusting The Oval Blade In The Counter-Blade - Nogueira VMN 4.0 Manual De Instrucciones

Adjusting the Oval Blade in the Counter-Blade

1- Turn the thread blade using the appropriate tool until it facing the counter-blade.
2- Loosen the screw and adjust the blade until it is at maximum 2 mm from the counter-blade. Then
tighten the screw.
3- Turn the thread until it gets to the next blade and then repeat the previous operation.
NOTE: This operation must be performed in order to also improve the cutting of the worn
blades.
DESCRIPTION FOR ORDERING PARTS
1) KIT (left blade, screw, washer and nut)
2) KIT (right blades, screw, washer and nut)
3) KIT (half moon blades, screw, washer and nut)
4) Left blade
5) Right blade
6) Half moon blade
7) Screw left-hand thread (with rounded anti-theft head)
8) Washer
9) Fastening nut
4
5
36
Instruction Manual
2
fig.1
QUANTITY
VMN-4.0 VMN-6.0
10 unit 18 unit
4 unit
7 unit 11 unit
10 unit 18 unit
4 unit
7 unit 11 unit
42 unit 66 unit
42 unit 66 unit
42 unit 66 unit
6
VMN-8.0
26 unit
4 unit 4 unit
15 unit
26 unit
4 unit 4 unit
15 unit
90 unit
90 unit
90 unit
7
8
9