Festo MPS 400 Serie Instrucciones De Utilizacion página 17

• Setting up the pneumatic circuit
–
–
•
Dismantling the pneumatic circuit
–
–
•
Noise due to escaping compressed air
–
–
© Festo Didactic 8136944
Connect the devices with plastic tubing with an outside diameter of 4 or 6 mm.
Push the pneumatic tubing into the push-in connector as far as it will go.
Switch off the compressed air supply before dismantling the circuit.
Press the blue release ring down so that the pneumatic tubing can be pulled
out.
Noise caused by escaping compressed air may damage your hearing.
Reduce noise by using pneumatic mufflers, or wear hearing protection if noise
cannot be avoided.
All of the exhaust ports of the components included in the equipment sets are
equipped with mufflers. Do not remove these mufflers.
Measuring Pro Station – Operating instructions
CAUTION
17