Changing Container During Surgery; Changing Instrument During Surgery - Hologic Aquilex Fluid Control System Instrucciones De Uso Y Manual Del Operador

System Operation
en
Container change during surgery
Instrument change during surgery
40 / 412

5.14 Changing Container during Surgery

The device system detects automatically the replacement of a container. The pump
will stop immediately, and the deficit display is locked to insure an accurate deficit
count is maintained. Brief fluctuations in the deficit calculation (< 10 s) may occur
when a container is replaced. The replacement of a container is indicated with the
message Container Change, Press Resume.
• Disconnect tubing from full containers.
• Immediately remove full containers from scale.
• Install new containers.
• Reconnect tubing to new containers.
• Press Pause/Resume button to resume procedure.
WARNING!
Fluid bag and container change during surgery
A fluid bag or container change during surgery is only allowed, if the fluid bag or
container holds at least 0,5 liters of fluid or waste. Otherwise, the deficit value may
be falsified. In this case, the manufacturer recommends manual deficit calculation.
WARNING!
Touching containers and their holders
Touching the containers and their holders as well as vibrations of the balancing
system should be avoided during surgery to prevent false detection of the con-
tainer change and not negatively affect the accuracy of the deficit calculation.
WARNING!
Change of the containers
Containers should be changed quickly to avoid affecting the accuracy of the deficit
calculation.
WARNING!
Accuracy of the deficit
To avoid affecting the accuracy of the deficit calculation ensure that the first step
of the container change is to disconnect tubing from the full containers. Reconnect
tubing to the new containers only if they are already inserted into the scale.

5.15 Changing Instrument during Surgery

NOTE!
Correct lumen calibration and deficit calculation
The calibration must be performed outside of the patient to ensure a correct lumen
calibration and deficit calculation.
NOTE!
Change the containers and bags during surgery
It is possible to change the containers and bags during surgery without losing the
previously measured deficit.
• Pause the pump by pressing Pause/Resume button.
• Press the Prime button for 2 seconds.
• Change the instrument.
• Fully open hysteroscope inflow stopcock.